To set up your Chaser CH-E80 (often identified as a standard 80mm thermal receipt printer), you typically need the
| Symptom | Likely Cause | Solution | |---------|--------------|----------| | Prints gibberish | Wrong driver (e.g., Epson) | Remove and reinstall correct driver | | Skips labels | Sensor mode wrong | Set to “gap” in utility | | Cuts half receipt | Page size mismatch | Define custom paper size (80mm x 297mm) | | USB not detected | Power cycle order | Connect USB only after driver install | | Slow network printing | Windows RAW vs LPR | Use LPR with queue name “lp” |
This usually indicates a baud rate mismatch (for Serial connections) or an incorrect driver (ensure you aren't using a 58mm driver for this 80mm printer).
Open the driver folder and locate the .exe file (often named something like POS Printer Driver Setup ). Right-click and select . 3. Select the Interface The installer will ask for the interface type. USB: Most common for single-station setups.
Pro Tip: Always restart your computer after installing a new driver for the changes to take full effect!