Insert the SRT device into the designated reset port or hold it against the optical sensor (often where the red light is located).

| Issue | Probable Cause | Solution | | :--- | :--- | :--- | | | No power from rig / Blown fuse | Check the rig's battery voltage and fuses. | | Reset Fails / Error Message | Poor connection | Clean the diagnostic port pins with contact cleaner. Ensure the tool is seated fully. | | Service Light Remains On | Underlying Fault | The machine may have a hardware fault (e.g., worn motor, damaged cable). Use the tool to read Error Codes first. Resetting is disabled if critical faults exist. | | Tool gets hot | Short circuit | Disconnect immediately. This suggests a low-quality clone tool or a wiring fault in the rig. |

Built-in circuit protection to prevent power surges from damaging the tool’s internal PCB. The Benefits of Using a Service Reset Tool 1. Zero Downtime